Peugeot 308 Key Fob: 10 Things I'd Like To Have Known Earlier
Peugeot 308 Key Fob Replacement
Peugeot's 308 may be catching on a little, but it still feels appealing. It's not the most luxurious vehicle in its class, but it's an enjoyable and relaxing driving experience.
Here at Coded Car Keys we are often asked to replace peugeot 308 key fobs. The following tips can help whether the problem is constant or intermittent.
Water Damage
If you happen to leave your fob in the midst of a puddle or get it wet during kayaking, swimming, canoeing, rafting or canyoning, it's probably to sustain water damage. Keep just click the following web site in a dry bag every time you go outdoors or do activities that could expose it to excessive water.
You'll also want to ensure that the fob is dry prior to opening it and re-using it. If you smell any odors from the fob (such as industrial liquid or windshield washer fluid) it is a indication that it's been submerged.
A circuit board that's wet can cause the battery to dump its charge, or even explode. If you can get your 308 keyfob out of the water and turn it upside up and shake as much water out as possible before opening the casing. Take the battery out, and then clean the circuit board using a cotton swab that has been dipped into 90-percent alcohol.
Other reasons that your Peugeot 308 remote entry keyless system may not work include a dead coin-cell battery or receiver module malfunction signal interference or a defective chip. If none of these are the problem, you can try resetting the system by removing the battery at 12 volts for about 15 minutes.
Dead Coin Battery
Peugeot cars come with remote start which allows drivers to start their car from an extended distance, which allows them to warm up or cool down the vehicle before they get in. This feature is extremely beneficial particularly in cold winter months. The remote start system may not function due to a variety of reasons, including the dead battery in the coin-battery.
A coin-shaped battery in the key fob will last a time of between two and four years, depending on how often it's used and the location where it was purchased. The date of use is usually written on the package or written in the manual.
If the key fob has stopped functioning after being exposed to clean tapwater, remove the battery and clean the electronic chip using an absorbent paper towel that has been soaked in isopropyl ethanol. Then dry the chip completely before replacing it. If exposed to soapy or salty water, the chip might be damaged and you'll have to replace the key fob in total.
If you are not sure the battery is in good condition You can test its voltage using an instrument set to the car's voltage range and connected to the terminals for minus and plus. The voltage should range from 12 to 13 volts, but if it's lower, the battery should be replaced. You can also reset the computer in the onboard computer by disconnection and reconnecting the 12 volt batteries in reverse order. (positive cable first then negative cable). The engine should then start after this.
Faulty Receiver Module
If you're not seeing the "Key Detected" message on your dashboard, it's possible that your receiver module has developed a fault. It's the part that sends out the signal when your key fob is activated. It also functions as an alarm and prevents the car from starting if you don't have the correct key.
This could be due to a range of factors including water damage or simply aging. If your Peugeot 308 key fob has been exposed dirty tap water, as in the chip that is located inside the device will be damaged. In this situation, you'll need to remove it and thoroughly clean it using isopropyl or electronic cleaner. When the battery is clean, you can try again.
If the problem persists the issue persists, it's a good idea to visit a local Peugeot specialist or locksmith. They'll be able to employ a diagnostic tool identify the issue and fix it.
It can be stressful to lose your Peugeot car key. However, a qualified auto locksmith can fix the issue in only a few minutes. They can cut a brand new key and then program it into your vehicle, ensuring you're on the road again in the shortest time possible. Find the nearest locksmith.
Faulty Electronic Chip
The electronic chip in the Peugeot 308 key fob plays a vital role in the remote control system. If it is damaged, your car might not start or you may get a message saying "anti-theft active". If this occurs, the only solution to fix the issue is to obtain a new key. Auto locksmiths who are professionals can provide this fastest possible time.
The chip inside the key fob of your Peugeot 308 may fail due to many reasons, such as water damage, sweat or dirt. If your Peugeot 308 key fob has been exposed to soapy water, clean it immediately. You can make use of a towel and isopropyl ethanol to clean the electronic component. After that, allow the battery to completely dry.
Radio interference can cause a key fob to cease working. This could be due to other devices use the same frequency as your Peugeot keyfob. It can also be caused by bad weather or objects in the vicinity. If you have this issue it is recommended to visit a Peugeot dealership.
The Peugeot Key Fob 207/308 is delicate and requires special care. You should not drop it or throw it around. If you lose something, try to locate it as soon as you can. You can reset the onboard computer by disconnecting the battery for a few minutes. Be sure to disconnect the negative cable first, and then the positive.